Delta Seal Leak Question

Post your windshield repair tips, questions, advice! Note there is a sub-forum specifically for business development questions.
Post Reply
ChipEliminator
Junior Member
Posts: 11
Joined: September 24th, 2011, 3:22 pm
Enter the middle number please (3): 3

Delta Seal Leak Question

Post by ChipEliminator »

ChipEliminator has been reading and looked at the training Video over and over. Been practicing also- still practing.... Noticed I do have some resin leaking out after 4 repairs.
Bridge Level ...2 full turns on back legs half turn once seal hits the glass. If I put too much resin in will this happen on psi cycle? I may have use more resin than needed is that a factor.
The reapir looks ok but I know resin should not leak. Maybe I am over tighten the seal? Thx Ahead of time.
Kgobin
Moderator
Posts: 1107
Joined: June 5th, 2008, 11:03 am
Enter the middle number please (3): 3
Location: Champaign, IL
Contact:

Re: Delta Seal Leak Question

Post by Kgobin »

Are you applying thumb pressure during the pressure cycle?

The goal is to get uniform thickness around end seal (so at times it might require more/less than the recommended steps). Without uniform thickness around he end seal you run the risk of the resin leaking or blocking the passage of the resin flowing into the break.
Korey Gobin
Delta Kits, Inc.
Image
ChipEliminator
Junior Member
Posts: 11
Joined: September 24th, 2011, 3:22 pm
Enter the middle number please (3): 3

Re: Delta Seal Leak Question

Post by ChipEliminator »

I am applying thumb PSI during the pressure cycle. The seal does look uniform on the glass. The seal itself looks flattend (more than it should ) I guess...
Kgobin
Moderator
Posts: 1107
Joined: June 5th, 2008, 11:03 am
Enter the middle number please (3): 3
Location: Champaign, IL
Contact:

Re: Delta Seal Leak Question

Post by Kgobin »

You could be applying too much thumb pressure, so I would suggest slight thumb pressure or no thumb pressure and see what happens.
Korey Gobin
Delta Kits, Inc.
Image
Kgobin
Moderator
Posts: 1107
Joined: June 5th, 2008, 11:03 am
Enter the middle number please (3): 3
Location: Champaign, IL
Contact:

Re: Delta Seal Leak Question

Post by Kgobin »

I'm available by phone right now so feel free to call if you like ( I emailed you the number).
Korey Gobin
Delta Kits, Inc.
Image
Post Reply

Who is online

Users browsing this forum: Google [Bot] and 21 guests