Are all or most injectors the same thread size? My question really is will my glasweld injector fit a delt bridge? I had to do several corner repairs today and i'm not digging the "crack and corner" bridge that I have.
Any imput would be great, Thanks.
Anyone know if....
Re: Anyone know if....
not sure about the glasweld, but it has been my experience that most are the same. Jeff can probably give you the size.
-
- Senior Member
- Posts: 626
- Joined: August 13th, 2003, 5:53 am
- Contact:
Re: Anyone know if....
NO, GW's injectors won't fit a Deltakits bridge
Re: Anyone know if....
Sunshine,
Do you have any tips for using GW for corners or edges? there must be a better way?
Do you have any tips for using GW for corners or edges? there must be a better way?
-
- Senior Member
- Posts: 626
- Joined: August 13th, 2003, 5:53 am
- Contact:
Re: Anyone know if....
I have the crack bridge with center bolt & leveling bolt on the end. I did have trouble at first but after some practice things got fine. GW also has a new corner bridge but I have not tried it.
Who is online
Users browsing this forum: No registered users and 0 guests