Pit filler

[Anonymous]

After I cure the resin and pit pit resin I scrape the excess w/razerblade. After excess is removed the it is kinda rough around where the hole was. It almost seems as its not completly filling in. Left light on it for 5 mins. Any ideas on what I am doing wrong? Thanks

[Anonymous]

Opey,

Are you...

1. Using a new razor blade
2. Holding the blade correctly
3. Using old or incompatible resins
4. Using good batteries and bulb in the UV lamp
5. Using cure tabs when curing
6. Using pressure when appling the cure tab
7. Using sufficient resin
8. Noticing this after you polish

Just a few things to consider.

Pay it foward,

Brian
www.safeglasstechnologies.com

[email]"info@safeglasstechnologies.com"[/email][/email]

[Anonymous]

Brian,

1. Using a new razor blade - Yes
2. Holding the blade correctly - I assume so
3. Using old or incompatible resins- New resin from Delta
4. Using good batteries and bulb in the UV lamp- Yes
5. Using cure tabs when curing- Tape and tabs, same results
6. Using pressure when appling the cure tab - no, just placing on top
7. Using sufficient resin - yes 7 drops
8. Noticing this after you polish - yes

[Anonymous]

Opey,

I assume thats 7 drops of the premium bond but are you applying enough pit filler to adequately fill and overlap the break?

Pay it foward,

Brian
www.safeglasstechnologies.com

[email]"info@safeglasstechnologies.com"[/email][/email]

[Anonymous]

Opey,

Have you determined the cause? If so, let us know. Thanks.

Pay it foward,

Brian
www.safeglasstechnologies.com

[email]"info@safeglasstechnologies.com"[/email][/email]