Page 1 of 1
Re: Need Help
Posted: April 23rd, 2003, 1:55 pm
by Anonymous
Im having problems with the small breaks that have a small dot with small wings. How do I repair these types of breaks?
chip repair
Posted: April 23rd, 2003, 2:25 pm
by Anonymous
how small are you talking about?
www.ohnonotagain.com
Re: chip repair
Posted: April 24th, 2003, 2:42 am
by Anonymous
rickyreed,
Based on your post, I assume you tried to fill the break with no luck and will also assume that the impact point or dot as you mentioned is very small almost like a nick and does not penatrate the outer layer of glass. Based on that I would drill and pop a bullseye to make sure legs are connected and fill and cure as normal. Hope I understood your post correctly and this helps.
Pay it foward,
Brian
www.safeglasstechnologies.com
[email]"
info@safeglasstechnologies.com"[/email][/email]
Re: chip repair
Posted: April 24th, 2003, 4:48 am
by Anonymous
bfenne
You are right about your thoughts. Next time I will drill halfway through the outer layer then pop a mini.
The break had not made it to the outer layer also. Do you still handle the break the same way.
break
Posted: April 24th, 2003, 7:16 am
by Anonymous
Rickyreed, once you have drilled and popped the mini, proceed as with any other repair.