Windshield Repair Forum

Can you post a photo of the one you are looking for? Maybe we have something on our trade-in shelf.

Hi Brent
It looks exactly the same as you magnetic silver punch that you offer, and I bought. The difference is just the carbide tip. Rather than have a taper to a point its "point is a straight parallel shaft about 1/8 long and the dia of it is small enough to fit into a drill hole. You have a video out I think for the slide hammer that shows a person using a drill hole depth gage. This is the same as what I'm looking for rather the end is longer so it bottoms out in the hole.

Can't say for sure without a photo but I didn't see anything like that in our collection of trade-in parts.

Johnny,
Why not just buy a slide hammer or the new spring loaded one? They both work fine, and will save you all this time you are spending on old technology. Good luck.