- Brent Deines
- Posts: 2442
- Joined: September 24th, 2003, 7:54 am
- Enter the middle number please (3): 5
- Location: Eugene, OR
- Has thanked: 95 times
- Been thanked: 195 times
Obviously you can use anything for the tapping but something light weight and made of wood or plastic seems to work best for me. The size and shape of the point are critical, and should be matched to the size and shape of the hole. That is why I use this carbide bur https://www.deltakits.com/?s=fg701&product_cat=0 and rotate the drill in a circular direction as I drill. That seems to work very well with the scribe, slide hammer, and spring hammer mentioned above. Better in fact than any other combination I have tried.
Others use needles or very sharp pointed scribes, and some use a wider point or blunt probe with different sized drill bits. I've found if the point is too sharp or the diameter of the point too small, very fine cracks often develop at the bottom of the drill hole, and small bullseyes are sometimes difficult to make. With too large of a diameter or a blunt point I've found you have to tap too hard, often causing the crack to run, or chipping around the drill hole.
If you come up with a combination that works better please share. There's no right or wrong as long as the method provides the desired results.
- Rating: 25%
Delta Kits, Inc.
- Posts: 139
- Joined: November 23rd, 2009, 1:16 pm
- Enter the middle number please (3): 3
- Has thanked: 6 times
- Been thanked: 28 times
Users browsing this forum: No registered users and 10 guests