Clean drilled injection site before repairing

Post your windshield repair tips, questions, advice! Note there is a sub-forum specifically for business development questions.
Post Reply
salvatoreali
Junior Member
Posts: 30
Joined: June 5th, 2013, 3:21 pm
Enter the middle number please (3): 3
Contact:

Clean drilled injection site before repairing

Post by salvatoreali »

Hello
Been a while. Often wondered how residual dist and moisture affected quality of repair but decided compressed air too costly and lugging compressor tank to customer's car unprofessional.
Solution? A $2 rubber bulb syringe from pharmacy similar to what a Dr would use to suction out a newborn baby's nostrils or what you use to irrigate an ear. Use it to blow dust from hole and site. If raining use suction to evacuate moisture from hole before injection of resin. Works like a charm! Noticed more complete filling of long spider legs.
User avatar
RHughes89
Junior Member
Posts: 17
Joined: March 15th, 2016, 11:06 am
Enter the middle number please (3): 3
Location: Ontario, Canada
Contact:

Re: Clean drilled injection site before repairing

Post by RHughes89 »

Sounds like the dust blower that came with my 450 kit but I dont know about the moisture removal aspect..
http://www.deltakits.com/shop/accessori ... ust-blower
Dave M
Senior Member
Posts: 648
Joined: August 9th, 2003, 6:13 am
Enter the middle number please (3): 5
Location: Westbrook, ME
Contact:

Re: Clean drilled injection site before repairing

Post by Dave M »

I've been using a rubber bulb syringe for years with great results (blowing out the pit area). Not a good tool to use for eliminating moisture. You've got to use some heat to evaporate the moisture from inside the break.
screenman
Senior Member
Posts: 3192
Joined: February 25th, 2004, 1:44 pm
Enter the middle number please (3): 5
Location: uk Lincolnshire
Contact:

Re: Clean drilled injection site before repairing

Post by screenman »

Suction alone will not remove moisture from a chip, to complete the task qickly I suggest the Drystar and a heatsink.
salvatoreali
Junior Member
Posts: 30
Joined: June 5th, 2013, 3:21 pm
Enter the middle number please (3): 3
Contact:

Re: Clean drilled injection site before repairing

Post by salvatoreali »

Heat at repair site NOT a problem in south Texas.
Have to worry about too much heat normally.
screenman
Senior Member
Posts: 3192
Joined: February 25th, 2004, 1:44 pm
Enter the middle number please (3): 5
Location: uk Lincolnshire
Contact:

Re: Clean drilled injection site before repairing

Post by screenman »

O.K. do not rub it in we in the UK had our summer Sunday morning :D , it is now straight back into miserable and wet. I honestly cannot remember the last time I did a repair without the need to use the 2 tools mentioned, it would be nice to have a few days where they stay in the toolbox.
Post Reply

Who is online

Users browsing this forum: No registered users and 7 guests