Rv windshield

Post your windshield repair tips, questions, advice! Note there is a sub-forum specifically for business development questions.
Post Reply
jdn
Junior Member
Posts: 27
Joined: August 14th, 2014, 7:11 pm
Enter the middle number please (3): 3
Contact:

Rv windshield

Post by jdn »

How do I do an rv windshield without the help of gravity pulling the resin down to the end seal?
User avatar
Brent Deines
Moderator
Posts: 2451
Joined: September 24th, 2003, 7:54 am
Enter the middle number please (3): 5
Location: Eugene, OR
Contact:

Re: Rv windshield

Post by Brent Deines »

Some bottom load but I prefer to just adjust my bridge so the injector has a slight upward angle to the glass and use a little extra resin. It does not take much of an angle to allow the end seal to fill.
Brent Deines
Delta Kits, Inc.
Image
User avatar
benswindshieldrepair
Member
Posts: 178
Joined: March 19th, 2011, 8:01 pm
Enter the middle number please (3): 3
Location: Flathead Lake, Montana
Contact:

Re: Rv windshield

Post by benswindshieldrepair »

On a typical car, you mount the bridge so that the suction cup is above the break. On an RV, I will oftentimes (depending on angle) mount it opposite this, and use the adjustment foot to create a little more angle on the barrel, if that makes sense. Like Brent said, a little more resin and it works fine. I usually charge extra for RV work as well...
Post Reply

Who is online

Users browsing this forum: No registered users and 6 guests