Liability Issues

Post your windshield repair tips, questions, advice! Note there is a sub-forum specifically for business development questions.
Auto Glass Rescue
Member
Posts: 132
Joined: July 21st, 2011, 7:21 am
Enter the middle number please (3): 3
Location: CenTex
Contact:

Re: Liability Issues

Post by Auto Glass Rescue »

Per ROLAGS:

7. Repair Limitations
Both the location and the condition of the damage are important considerations in the decision to repair. Replacement is recommended under any of the following circumstances, i.e., do not repair:

• In the Driver’s Primary Viewing Area (DPVA) if:
• Diameter of damage is larger than one inch (25 mm);
• The finished pit will be greater than 3/16 inch (5 mm);
• The repair will be within 4 inches (100 mm) of another repair (see 5.1);
screenman
Senior Member
Posts: 3192
Joined: February 25th, 2004, 1:44 pm
Enter the middle number please (3): 5
Location: uk Lincolnshire
Contact:

Re: Liability Issues

Post by screenman »

Do you know they are much the same rules as Belron pushed through here years ago. Although a standard they are different from out ministry test. Look at them they are ridiculous, why not less than 4 inch apart, easy the old Glass Medic kit did not like to do repairs that close, why a pit smaller than 3/16 no problem out of the drivers view, how many windshields are that clean. Why not longer than 1 inch, a nice clean star say 1 1/2 inches as we all know will come out lovely, OK maybe not in the Azone but any were else is fine.

These standards were dreamed up by replacement companies who at the time and still are useless at repairing. They were very nearly a lot tougher it is only because some of us fought and fought hard years ago that they are not.

Rant over.
Frank EU
Senior Member
Posts: 771
Joined: December 13th, 2005, 9:01 am
Enter the middle number please (3): 5
Location: Europe / US
Contact:

Re: Liability Issues

Post by Frank EU »

If, and only if, you are a serious repairer, please read the post above. And reread it. Screenman is right.
Post Reply

Who is online

Users browsing this forum: No registered users and 6 guests