Page 1 of 1

Pit resin taking longer to cure

Posted: June 29th, 2016, 2:12 pm
by davidsleg09
My last few repairs I have noticed the pit resin is taking a lot longer to cure. I know I'm not as busy as most of you so i dont go through a bottle as fast and I'm still fairly new but does this stuff have a shelf life? Everything I use is the same and I do my best too keep out of extreme temps. Any help would be appreciated. Thanks.

Re: Pit resin taking longer to cure

Posted: June 29th, 2016, 9:16 pm
by screenman
Never had that happen, what type of curing lamp are you using?

Re: Pit resin taking longer to cure

Posted: June 30th, 2016, 6:52 pm
by davidsleg09
I have the same uv light I've been using, just came with the kit. It worked fine before

Re: Pit resin taking longer to cure

Posted: June 30th, 2016, 10:16 pm
by screenman
How old is the bulb in your light, assuming it is not not LED.

Re: Pit resin taking longer to cure

Posted: July 5th, 2016, 4:13 pm
by Brent Deines
Assuming it's Delta Kits resin it's not likely a shelf life issue or even a resin issue for that matter unless it has been contaminated somehow.

The UV light would be the number one suspect. Could be the bulb or batteries if battery operated. Could also be the circuitry but that is pretty rare.

What are you using for curing tabs? Fairly commonly we find that customers are using some sort of film that actually blocks UV light.

If you have Delta Kits resin and a Delta Kits curing tab or film try curing a drop of pit resin in bright sunshine. It should be plenty hard enough to scrape flat within 2 minutes. If so it almost has to be your light. If not, it almost has to be a resin contamination problem although we rarely see contamination issues unless you are reusing bottles or adding something to the resin purposely.

If you do feel it is a resin issue please give us a call or send the resin to us for testing. We guarantee our resins 100%.

If not using Delta Kits products there may be other causes that I am not familiar with.

Re: Pit resin taking longer to cure

Posted: July 8th, 2016, 4:53 pm
by candyman
A few years ago , I had a similar issue. I discovered two things. 1. My battery needed replacing and wasn't strong enough. 2. I needed to leave the lamp on longer for certain breaks and weather conditions. . I have not used the small box UV in several years now. I use either the small UV Pin light from Delta or my long white light, depending on size of the break.

Re: Pit resin taking longer to cure

Posted: July 8th, 2016, 4:54 pm
by candyman
A few years ago , I had a similar issue. I discovered two things. 1. My battery needed replacing and wasn't strong enough. 2. I needed to leave the lamp on longer for certain breaks and weather conditions. . I have not used the small box UV in several years now. I use either the small UV Pin light from Delta or my long white light, depending on size of the break.